Alpine PXA-H701 Calling out stored values, Storing settings in the memory, Defeat mode

Convenient Functions

Calling out stored values

1 Press any button from 1 to 6 to select the preset memory you want to call out (“MEMORY1” to “MEMORY6”).

In the preset memory, numerous settings/ adjustments are stored. Therefore, it may take some time to access the stored preset memory.

DEFEAT 1~6 DISP

Storing settings in the memory

LOAD I NG

PRESET MEMORY 1

NOTE

This operation can only be performed when the defeat mode is turned off.

This function can store up to 6 adjustments/ settings.

The following adjustments/settings are stored in a preset memory. For more details, see each page for the below items.

Page 4: Speakers Setting / Pages 6 - 11: Time Correction/Phase Switching/Bass Focus Setting / Pages 12 - 14: Equalizer Adjustment / Pages 15 -

17:X OVER Adjustment / Pages 18 - 19: MX Settings / Page 19: BASS COMP. Setting / Page

20:Pro Logic II Mode Setting/Center Width Adjustment* / Pages 21 - 25: Dolby Surround adjustment* / Page 26: Linear PCM Setting* * Depending on the signal input, there is no

effect.

1Make the adjustment or setting you want to store in the memory.

2Press and hold any button from 1 to 6 for at least 2 seconds to store the setting into preset memory (“MEMORY1” to “MEMORY6”).

SAVE

PRESET MEMORY 2

Defeat mode

1 Press the DEFEAT button. All properties are made flat.

DEFEAT ON

2 Press the DEFEAT button again to cancel.

NOTES

•The “Parametric EQ”, “Graphic EQ”, “AUTO TCR”, “TCR/phase switching”, “MX”, “X-OVER” and “BASS COMP. setting” operations cannot be performed when the defeat mode is turned on.

•To protect the speakers, the “X-OVER” setting does not change.

NOTES

•This operation can only be performed when the defeat mode is turned off.

•The stored contents will not be deleted even when the battery power cord is detached.

28-EN