Altec Lansing IM414V2 The Power LED is not lit, AC Operation, No sound is coming, from speakers

		Troubleshooting
Symptom	Possible Problem	Solution
	The power supply cord isn’t connected to a	Insert the barrel connector from the power supply into the DC connector on
	wall outlet and/or the power supply connector	the back of the inMotion system. After this connection is made, insert the
	is not plugged into the power supply jack on	power supply into a wall outlet.
	the back of the inMotion system.
The Power LED is not lit
	The surge protector (if used) isn’t powered on.	If the power supply cord is plugged into a surge protector, make sure the
(AC Operation)		surge protector is switched on.
	The wall outlet is not functioning.	Plug another device into the same wall outlet to confirm the outlet is working.
	The power isn’t turned on.	Turn on the inMotion system by pushing the power button located to the left
		of the docking station. The LCD screen will turn on.
		Press the “+” button to increase the volume to the desired level.
	The volume is set too low.
		Check the volume level on alternate audio source device and set at mid-level.
No sound is coming	The Zune player is not correctly seated into	Turn off the Zune player, remove it from the docking station, reseat it, and turn
	the docking station.	it on again.
from speakers
	If using an alternate audio source, the audio	Follow the instructions in Connecting to an Alternate Audio Source.
	source is not properly connected to the	If necessary, try connecting another audio source.
	inMotion system or there is a problem with
	the alternate audio source.

3