Altech Auto Security AL7024S manual First steps first, Checklist for first Tests, Instruction

AL7024S Quick Start Manual

1.First steps first

1.1Checklist for first Tests

STEP	Instruction
1	Test SIM-card with a handy, decide if you want to use a PIN-code or not and
	note it.
2	Connect Hardware
	(5V-supply, RS-232-interface with 5V-levels, Antenna, SIM-card)
	Set serial-port baud-rate of DTE to 115200 baud, 8n1, hardware-handshake
3	(Soft-handshake not supported). The module should react already to AT-
	Commands, even if it is not connected to a network. If it is not reacting, try
	also 9600 baud. After getting responses from modem, set it to autobaud with
	‘AT+IPR=0’ and store the setting with ‘AT&W’.
	If no SIM-PIN-code is needed, the module should be connected to the
	network some seconds after power-up. (With the command ‘AT+CPIN?’ you
	can test if the Module requires PIN. Response ‘SIM PIN’ for yes, ‘READY’
4	for no.)
	If a PIN is used, enter it with 'AT+CPIN=”....”. The module answers with ‘OK’
	and connects to network. It uses the providers in the ‘preferred-operators-
	list’ (see AT commands interface guide).
5	Check the connection status of the modem. It can be seen by the flashing
	LED (Pin 29 of Socket) and the response "+CREG: 1,1" (After issuing the
	command 'AT+CREG=2').
6	The reception-quality can be seen with 'AT+CSQ'. A reception level of at
	least 10 to 15 is needed for safe operation.
	Configure the module for your needs (baud rate, information commands etc.,
7	see below)
	Set data-mode to V110 9600 baud with 'AT+CBST=71,0,1' and configure the
	other side of communication to the same. Set ‘ATS0=2’ at the other side.
8	Call the other side by 'ATD..........'.
9	If the other side calls you, set 'ATS0=2' before, so the module will answer
	after 2 rings.
	For a test-voice-call, you could call a telephone or a portable phone with
10	‘ATD…. ;’ (Semicolon for voice mode). A headset can be connected to the
	module to speak to the other side.
11	Send an SMS to a portable. See following example:
	AT+CMGS=”0764359988” <CR> Call me today <ctrl-Z>
12	Send DTMF tones to a phone. ‘AT+VTS=1’ sends digit ‘1’. Only one digit can
	be transmitted with this command, so you have to repeat it to send longer
	numbers.

No. AL7020S-QSM-101 Altec Electronic AG Seite 4 / 18