MULTITASKER
26.[MODEN]
This command is used to turn the digital noise reduction feature on and off.
Command Format: [MODENpCn]
p = Noise Reduction ON/OFF (p = 0 or 1)
0= OFF
1= ON
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [MODEN1C4] to turn on noise reduction for the
27.[MODEA]
This command is used to change the aspect ratio between wide and standard formats.
Command Format: [MODEApCn]
p = Aspect Ratio (p = 1 or 2)
1= Wide 16:9
2= Standard 4:3
Cn = Card ID (n = # from 1 to max slots) Example:
Send the command [MODEA1C4] to set the aspect ratio to Wide format on the
28.[FREEZ]
This command is used to freeze the image displayed on the display.
Command Format: [FREEZpCn]
p = Freeze value (p = 0 or 1)
0= OFF
1= ON
Cn = Card ID (n = # from 1 to max slots)
Example:
Send the command [FREEZ1C4] to freeze the image generated by the
29.[ + ]
This command increments a selected property to be adjusted from the keyboard or front panel.
Command Format: [+] or [+k]
[+]= Increment by one [+k] = Increment by “k”
Example:
Select the brightness command for the card in slot 4. The current brightness level is 10, but it is not the optimal value. After sending the following commands, an optimum level of 15 is obtained:
1.[BRIGHTC4]
The current brightness level is 10.
2.[+][+][+][+][+] or [+5]
The level is now 15 and no further adjustments are required.
30.[ - ]
This command decrements a selected property to be adjusted from the keyboard or front panel.
Command Format:
Example:
Select the sharpness command for the card in slot 4. The current sharpness level is 30, but it is not the optimal value. After sending the following commands, an optimum level of 25 is obtained:
1.[SHARPC4]
The current sharpness level is 30.
2.
The level is now 25 and no further adjustments are required.
14 |
