Amana ARTC7114*, ARTC7003* owner manual Other Features

Other Features
Adjusting Factory	Oven temperature is set at factory. When first using oven, follow recipe times and
Set Baking	temperatures. If you think oven is too hot or too cool, temperature can be adjusted. Before
Temperature	adjusting oven baking temperature, test a recipe by using a temperature set higher or
	lower than the recommended temperature. The baking results should help you to decide
	how much adjustment is needed.
	1. Turn oven temperature knob to OFF.
	2. Press and hold HRS + and HRS - pad for approximately 5 seconds.
	•	Display shows current offset temperature.
	3. Immediately, press either HRS + or HRS - pad.
	•	HRS + increases oven temperature by 5°F.
	•	HRS - decreases oven temperature by 5°F.
	• Oven temperature can be changed up to 35°F. When temperature is adjusted cooler
		“-” shows in display followed by offset temperature.
	•	After a few seconds control saves setting and returns to previous display.
12-hour automatic	As a safety feature, oven control automatically shuts off oven after 12 hours of operation.
cancel	This feature can be turned on or off.
	To allow the oven to operate for more than 12 hours, confirm temperature knob is in OFF
	position. Then, press and hold the MINS + and - pads for approximately
	4 seconds. Display will change from time-of-day and show “OFF”.
	To set oven to shut off after 12 hours, confirm temperature knob is in the OFF position.
	Then, press and hold the MINS + and - pads for approximately 4 seconds. Display will
	change from time-of-day and show “ON”.
Service codes and	Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
tones	alerts you if there is a error or problem in the control. When electronic range control signals
	a problem, follow steps listed below.
	1. Record “F-code” shown.
	•	FFF—control malfunction.
	•	F2—high oven temperature.
	•	F3—open temperature sensor or circuit malfunction.
	•	F4—shorted temperature sensor or circuit malfunction.
	2. Disconnect and reconnect electrical supply.
	• Disconnecting electrical supply may eliminate “F-code”. If failure continues, contact
		an authorized servicer.

15