Converting 3-Wire to 4-Wire Power Cord
1.Remove rear wire cover.
2.Remove bottom strain relief screw and retain for further use.
3.Remove screw/hex nuts from terminal block and retain for further use.
4.Remove all
5.To install the
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a properly installed
1.Measure 31/2 inches from back wall on right and left side of cabinet cutout. Mark measurements on floor and draw a straight line connecting marks.
2.Position
•If range is installed beside cabinet(s), place
•If range is not installed beside cabinet(s), position range where it will be installed. Draw a line along side of range on floor from front to back. Remove range. Place
•
or
3 1/2"
3.Mark 2 hole locations in
4.Drill 2 holes.
•If drilling into wood, use a
•If drilling into concrete, use a
5.Secure bracket to floor using screws supplied.
6.Slide range into position, remove range storage drawer or lower panel and confirm
Level Range
!CAUTION
To avoid damaging oven door, do not lift or move range by oven door handle. Glass can break.
Carefully level range using legs provided. Range must be level to cook and bake uniformly.
•Place a level on top oven rack or on range top when leveling.
•Leveling legs must extended ¼ inch to engage
Removal and Replacement of Range
1.Disconnect power to range.
2.Slide range forward.
3.Unplug range cord and place range aside.
4.Remove
5.Install
6.To reinstall range, follow instructions in Installation section of this manual.
9
