Amana LD10D2 Installation, Cooking Guidelines, Unpacking Equipment, Radio Interference

Models: LD10D2

1 16
Download 16 pages 2.01 Kb
Page 8
Image 8
Installation

Installation

Cooking Guidelines

Unpacking Equipment

Inspect equipment for damage such as dents in door or dents inside oven cavity.

Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.

Remove all materials from oven interior.

If oven has been stored in extremely cold area, wait a few hours before connecting power.

Radio Interference

Microwave operation may cause interference to radio, television, or similar equipment. Reduce or eliminate interference by doing the following:

Clean door and sealing surfaces of oven according to instructions in “Care and Cleaning” section.

Place radio, television, etc. as far as possible from oven.

Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.

Equipment Placement

Do not install equipment next to or above source of heat, such as a deep fat fryer. This could cause microwave oven to operate improperly and could shorten life of electrical parts.

Do not block or obstruct oven filter. Allow access for cleaning.

Install oven on level countertop surface.

A

A Cooking Guidelines

A

B

The Amana Microwave Oven can make your job easier. You’ll cook ahead and pre-portion more. You’ll also spend less time preparing special-order dishes.

To be sure of consistently good results, remember a few simple guidelines.

How Microwave Ovens Heat Food

All food and liquid molecules have positive and negative particles which are in constant, but slow, motion. (Positive and negatives attract and repel each other like magnets.) In microwave cooking this molecular action is then accelerated. The instant microwaves bombard food they agitate the molecules. Agitation causes friction as molecules rub and bump into each other at a increased rate. Friction results in heat that cooks food and boils water.

Once the microwaves stop, this friction action continues by itself, eventually tapering off and returning to normal molecular action.

Microwaves penetrate food to a short depth.

As cooking begins, heat is spread by conduction to the interior portion of the food just as in conventional cooking methods.

Food Variables

Microwave cooking can be directly affected by different food variables.

The shape of foods can greatly affect the amount of cooking time. Foods that are flat and thin heat faster than foods which are chunky. For example, a casserole will cook faster in a flat dish, rather than if heaped in a small dish. Foods cut into small pieces will cook faster than large-shaped foods. Pieces should be of a uniform size and shape for more uniform cooking, or the smaller pieces will cook faster. The greatest amount of heating takes place near the food’s surface. The interior of large

food items, or dense foods, is heated by the heat con- ducted from the outer food layer. The most uniform heating occurs in flat, doughnut-shaped foods. For best results, cook foods together which have similar sizes and shapes.

A—Allow at least 3 inches(7.62 centimeters) of clearance around top and sides of equipment. Proper air flow around equipment cools electrical components. With restricted air flow, oven may not operate properly and life of electrical parts is reduced.

B—Allow at least 3 inches from door front to edge of countertop to avoid accidental tipping of oven.

Oven Clearances

8

Page 8
Image 8
Amana LD10D2 owner manual Installation, Cooking Guidelines, Unpacking Equipment, Radio Interference, Equipment Placement