3.3VGA display software configuration
The PCM-5820 Series on-board VGA/LCD interface supports an 18-bit TFT LCD, flat panel displays and traditional analog CRT monitors. The interface can drive CRT displays with resolutions up to 1024 x 768 in 16 bpp. It is also capable of driving color panel displays with resolutions of 1024 x 768 in 18 bpp. The LCD type is configured completely via the software utility, so you do not have to set any jumpers. Configure the LCD type as follows:
1.Apply power to the PCM-5820 Series with a color TFT display attached. This is the default setting for the PCM-5820 Series. Make sure that the AWDFLASH.EXE and *.BIN files are located in the working drive.
Note: | Make sure that you do not run AWDFLASH.EXE |
| while your system is operating in EMM386 mode. |
2.At the prompt, type AWDFLASH.EXE and press <Enter>. The VGA configuration program will then display the following:
Figure 3-2: BIOS VGA setup screen
Chapter 3 Software Configuration | 33 |