important Sd card information & Set-up
SD CARD INFORMATION:
•Make sure your SD Card only has MP3 files on it
•Do Not have any other file type on your SD Card; no photo files, etc...
•American Audio SD Players can read SD HC (High Capacity) Cards up to 32GB
Please note:
For higher quality MP3 files (more than 128 kbps) American Audio recommends "High Speed" SD Cards. Using high speed cards will ensure the best performance with your American Audio SD Player.
USB INFORMATION:
•Make sure your USB device has only MP3 files on it. There cannot be any other type of files on your USB device, NO photo files, etc...
•If you are using a SD Card via USB SD Card reader, you must remove the USB SD Card reader first to change SD Card's. Please do not remove the SD Card from the USB SD Card reader while the USB card reader is still connected to the unit.
•Only supports FAT/FAT32 formatted devices.
1.Checking the Contents
Be sure your Radius 3000™ was shipped with the following: |
| ||
1) | Radius 3000™ Professional CD/SD/USB player. | 2) | User Guide and Reference Manual |
3) | One (1) set of RCA cables. | 4) | One (1) 1/8” Relay Cable. |
5) | USB Cable. | 6) | Warranty card. |
2.Installing the Units
Place your unit on a flat surface or mount it in a flat surface case.
3.Connections
1)Be sure the power is disconnected.
2)Connect the included RCA cable from your Radius 3000™ outputs to the inputs on your mixer.
3)Use the supplied 1/8” mini plug cable to connect your Radius 3000™ to a mini jack connection (A or B ) on a compatible American Audio® or American DJ® “Fader Q Start” mixer. (This will enable the Fader “Q” Start function)
CAUTION:
•Be sure to use the supplied mono 1/8" control cables. Using other types of cable may result in unit damage
•To avoid severe damage to the unit, be sure the power is off when making connections to
the unit.
CAUTION:
•The VFD is designed to be clearly visible at any angle but is best viewed within the angles shown in Figure 1.
50˚ 10˚
Figure 1
©American Audio® - www.AmericanAudio.us - Radius 3000™ Instruction Manual Page 8
