GAS VALVE/IGNITION SYSTEM COMPONENTS:
For Models M31,M50,M75
IGNITOR
BURNER TUBE
GAS VALVE
OVEN HOUSING COMPONENTS:
Dual Burner M50,M75
TUMBLER SUPPORT
WHEEL ASSEMBLY REPLACEMENT:
The front wheel assemblies can be replaced with the lower front panel removed. Remove the three bolts by reaching upward with a socket or box wrench. The illustration below is provided to show the location of these wheels as the wheels cannot easily be seen while standing in front of the dryer.
For Models M31
OVEN CHAMBER
RADIANT
SENSORS
RADIANT SENSOR
HOTSURFACE
IGNITOR
BURNER
GAS VALVE
The left rear wheel assembly can be removed with just the back guard removed. The rear right wheel requires removing the back guard, heat duct, and oven. Be sure to mark the position of rear wheel brackets prior to removal (refer to photo right).
All wheel assemblies are mounted on slots to allow for alignment of the tumbler. After one or more wheel assemblies are replaced, the tumbler must be realigned.
For Models M50,M75
HOT SURFACE
IGNITOR
6 | American Dryer Corporation |
