American Dryer Corp ML-75DII

SECTION IX

DATA LABEL INFORMATION

A. DATA LABEL

Contact American Dryer Corporation

When contacting American Dryer Corporation certain information is required to insure proper service/parts

information from American Dryer Corporation. This information is on the data label located on the left side

panel/wall area behind the control door. When contacting American Dryer Corporation please have the

model number and serial number available.

Contents

Main ML-75DII (Gas/Electric/Steam) Installation Manual Retain This Manual In A Safe Place For Future Reference ML-75DII Important Page Page Table of Contents Page SECTION I IMPORTANT INFORMATION A. RECEIVING and HANDLING B. SAFETY PRECAUTIONS Page SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION GasElectricSteam A. SPECIFICATIONS Shaded areas are stated in metric equivalents Page Page Page SECTION III INSTALLATION PROCEDURES A. LOCATION REQUIREMENTS IMPORTANT: The dryer must be installed on noncombustible floors only. B. UNPACKING/SETTING UP C. DRYER ENCLOSURE REQUIREMENTS D. FRESH AIR SUPPLY E. EXHAUST REQUIREMENTS Page Page Page Page F. ELECTRICAL INFORMATION MLG-75 (GAS) MLS-75 (STEAM) ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER) MLE-75 (ELECTRIC) ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER) IMPORTANT: For personal safety and proper operation, the dryer must be grounded. NOTE: A wire diagram is located in the front electrical control box for connection data. NOTE: A CIRCUIT SERVICING EACH DRYER MUST BE PROVIDED. Single-Phase (1) Electrical Connections Leads NOTE: A CIRCUIT SERVICING EACH DRYER MUST BE PROVIDED. Page IMPORTANT: A separate circuit servicing each dryer must be provided. Page G. GAS INFORMATION TYPE OF GASL.P. TYPE OF GAS NATURAL LIQUID PROPANE Page H. STEAM INFORMATION IMPORTANT: Coil failure due to improper PH level will VOID THE WARRANTY. IMPORTANT: Steam coil failure due to water hammer by wet steam will VOID THE WARRANTY. OPERATING STEAM PRESSURE Page COMPRESSED AIR SUPPLY AIR PRESSURE Normal 80 PSI 5.51 bars Minimum Supply 70 PSI 4.82 bars Maximum Supply 90 PSI 6.20 bars Page I. PREPARATION FOR OPERATION/START-UP J. PREOPERATIONAL TESTS Page K. PREOPERATIONAL INSTRUCTIONS L. SHUT DOWN INSTRUCTIONS SECTION IV SERVICE/PARTS INFORMATION A. SERVICE B. PARTS SECTION V WARRANTY INFORMATION A. RETURNING WARRANTY CARD(S) B. WARRANTY C. RETURNING WARRANTY PART(S) Page SECTION VI ROUTINE MAINTENANCE A. CLEANING Page B. ADJUSTMENTS C. LUBRICATION SECTION VII Page Page SECTION VIII REVERSING TIMER SPIN/DWELL ADJUSTMENTS TIMING LEGEND SPIN TIME DWELL (Stop) TIME Page THE DATA LABEL SECTION X BURNER and BASKET (TUMBLER)/LINT CHAMBER FOR PHASE 6 MODELS (GAS MODELS ONLY) FOR PHASE 6 MODELS (ELECTRIC OR STEAM MODELS ONLY)