American Dryer Corp MLG31PCB Electrical Service Specifications PER Pocket GAS only

3.Grounding

Grounding (earth) connections must be provided and installed in accordance with state and local codes. In the absence of these codes, grounding must conform to applicable requirements of the National Electrical Code ANSI/NFPA NO. 70-LATEST EDITION, or in Canada, the installation must conform to applicable Canada Standards: Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION. The ground connection may be to a proven earth ground at the location service panel.

For added personal safety, when possible, it is suggested that a separate ground wire (sized per local codes) be connected from the ground connection of the dryer to a grounded cold water pipe. DO NOT ground to a gas pipe or hot water pipe. The grounded cold water pipe must have metal-to-metal connections ALL the way to the electrical ground. If there are any nonmetallic interruptions, such as, a meter, pump, plastic, rubber, or other insulating connectors, they must be jumped out with No. 4 wire and securely clamped to bare metal at both ends.

IMPORTANT: For personal safety and proper operation, the dryer must be grounded.

4.Electrical Service Specifications (per pocket)

IMPORTANT: The dryer must be connected to the electrical supply shown on the data label.

WARNING: Any damage done to dryer components due to improper voltage application or connections will automaticallyVOID THE WARRANTY.

ELECTRICAL SERVICE SPECIFICATIONS (PER POCKET) GAS ONLY

SERVICE		WIRE	APPROX.	MINIMUM	FUSING	CIRCUIT
	PHASE		AMP DRAW
VOLTAGE		SERVICE		WIRE SIZE	Dual Element	BREAKER
			60 Hz		Time Delay
115	1ø	2	7.8	*	15	15
* AWG Stranded Wire Type - size wire as per National Electrical Code or local codes.						3/15/05

NOTE: Contact factory for electrical information not listed.

NOTES: 1. Fuse ratings are dual element time delay current limiting, class RK1 or RK5 ONLY.

2.Circuit breakers are thermal-magnetic (industrial) motor curve type ONLY. For others, calculate/verify correct breaker size according to appliance amp draw and type of breaker used.

NOTE: Manufacturer reserves the right to make changes in specifications at any time without notice or obligation.

113203-3 Maytag 19