MegaPower LT

Supported Protocol

SensorNet

Maximum Presets

96

Maximum Patterns (1)

3

Quick Set Menu

Yes (2)

Address Range

1-32

Notes:

(1)Patterns are limited by time and the number of available dome commands. Total time for each pattern cannot exceed 6 minutes 50 seconds. Total dome commands used in all patterns cannot exceed 99.

(2)Requires a compatible keyboard.

MegaPower 48

Supported Protocol

SensorNet

 

RS-422

 

 

Maximum Presets

96(1)

 

 

Maximum Patterns (2)

3

 

 

Quick Set Menu

Yes (3)

 

 

Address Range

1-48

 

 

Notes:

(1)Preset information is stored at the host, not the dome.

(2)Patterns are limited by time and the number of available dome commands. Total time for each pattern cannot exceed 6 minutes 50 seconds. Total dome commands used in all patterns cannot exceed 99.

(3)Requires firmware 1.07 or newer and a compatible keyboard.

MegaPower 1024

Supported Protocol

RS-422 (1)

Maximum Presets

16 (2) or 60 (3)

Maximum Patterns (4)

3

Quick Set Menu

Not supported

Address Range

1-1024 (5)

 

 

Notes:

(1)Requires the AD2083-02 series code converter.

(2)Preset information is stored at the converter, not the dome.

(3)Requires AD2083-02 with firmware version 0701- 11YB-156A or newer. Preset information is stored in the dome, not the converter.

(4)Patterns are limited by time and the number of available dome commands. Total time for each pattern cannot exceed 6 minutes 50 seconds. Total dome commands used in all patterns cannot exceed 99.

(5)Requires additional equipment to achieve these numbers. A dome address within each group of 64 or 99 cameras is reserved as a global broadcast address.

Panasonic UTC Protocol Preset Programming

The Dome Configuration Menu must be used to program Presets. Up to 64 Presets may be programmed using the Panasonic UTC protocol.

These instruction apply to the following equipment:

•Panasonic WJ-SX550 Multiplexer

•Panasonic WV-CU550A Controller

1.Select the monitor and camera number assigned to the Speed Dome Ultra VII camera dome.

2.Use the arrow keys on the controller to scroll to the Camera Setup Menu (D4).

3.Press F1 (On) key to display the Dome Configuration Menu.

4.Use the joystick to move the highlight to Alarms/Areas/Home/Presets/PZ. Press Set to select.

ALARMS/AREAS/HOME/PRESETS/PZ

SET ALARM ACTIONS

SET ALARM STATES

SET HOME POSITION

SET NORTH POSITION

AREA BOUNDARIES

PRIVACY ZONES

PRESETS

SCAN LIMITS

EXIT

SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY OPERATOR’S MANUAL SUPPLEMENT

8200-0184-09, REV. A

9 of 13