American Dynamics RAS915, RAS916, RAS917 AD Up-the-CoaxProtocol, Programming Scan Limits, AD-UTCCommand Summary

Programming Scan Limits

Refer to the SpeedDome Ultra VII Operator’s Manual for information about displaying menus and changing settings.

1.Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.

2.Select Scan Limits.

The Scan Limits screen appears:

SCAN LIMITS

PAN to LEFT limit

ZOOM to mark BOUNDARY

Cancel RIGHT limit to Delete

CANCEL

Note: Press Focus during steps 3 or 4 to cancel scan limit programming.

3.Adjust the pan position of the dome to set the left scan limit. Press Zoom to select.

4.Pan the dome to the right to set the right scan limit. Press Zoom to select.

5.When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit to return to the Dome Configuration Menu.

AD Up-the-Coax Protocol

The AD Up-the-Coax (AD-UTC) protocol is a new protocol developed by American Dynamics. It provides video and two-way dome control signals on a single cable for compatible American Dynamics switchers and keyboards.

Note: At the time of publication, the following American Dynamics keyboards are compatible with AD-UTC protocol: ADCC0200 and ADCC0300. The commands provided in this document assume that one of these keyboards is being used. Contact your Sales Representative for current information.

AD-UTC Command Summary

Table 3 lists the commands to operate the configuration utility in AD-UTC environment. The keyboard must be in programming mode to perform these functions.

Table 3: Configuration Menu Commands

Command			Function
F	,	+	Start the configuration utility.
(Function, and
then Shift+Menu)
Joystick			Move the highlight bar on the
(Pan/Tilt)			active menu.
		(Focus Far)	Select the highlighted item on
			the active menu.
		Or
	(Focus Near)
		(Zoom In) or	Increase the value of the
			selected setting.
Twist joystick
			Display the next choice for the
clockwise
			setting.
		(Zoom Out)	Decrease the value of the
			selected setting.
or Twist joystick			Display the previous choice for
counterclockwise
			the setting.
F	,	+	Save changes and exit the
(Function, and			utility from any screen.
then Shift+Clear)

When setting names or entering password information, the screen displays the available characters in the selected language. Table 4 provides the name programming and password entry commands:

Table 4: Name Programming/Password Entry Commands

Command	Function
Joystick	Move the highlight left or right
Left/Right	in the character field.
Joystick Up/Down	Move the highlight up or down
	in the character field.
(Focus Far)	Select the highlighted
	character in the character
Or	field.
(Focus Near)

SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY OPERATOR’S MANUAL SUPPLEMENT

8200-0184-09, REV. A

5 of 13