Ups | American Power Conversion 10-40kW 208/480V manual

Stop/Start UPS and Operating the External Service Bypass

CAUTION!

Do not leave UPS out of service for more than 48 hours. Refer to section 2.3 Stop (for complete power down).

2.5.2Switching the Single System UPS from External Bypass into Normal UPS Operation

Utility

Load

Service Bypass

Switch

APC Silcon

UPS

990-4034

10	User Guide APC Silcon 10-40kW 208V/480V UPS

Image 10

American Power Conversion 10-40kW 208/480V manual Ups

Contents

APC Silcon 10-40kW 208/480V UPS User Guide Copyright 2000 APC Denmark ApS User Guide APC Silcon 10-40kW 208V/480V UPS Safety Symbols used in this manualThank You Contents Introduction IntroductionDisplay Unit Stop UPS for stand-by Stop/Start UPS and Operating the External Service BypassStart UPS from stand-by Stop UPS for complete power down Switching off the UPS Start UPS from complete power down UPS start-up System start-up now completed Operating the External Service Bypass Switch single systems Bypassing the Single System UPS UPS YES Bypassing the Parallel UPS System All UPSs Acoustic alarm sounds for 30 secs Stop/Start UPS and Operating the External Service Bypass Set input switches Q001 to position Isolating one UPS in a Parallel/Redundant System Operation OperationKeyboard Display of Measured Values Batt. load Batt. tank Using the Remote Display Economy Mode Parameter Settings Parameter SettingsParameter Settings Programming Keys Switching to Bypass OperationProgramming Example Load power xx% Displaying the Alarm Stack Alarms and EventsAlarms and Events Mode Comments Possible Alarms Displaying the Event Stack Temperature of main inverter, too Unlock Parallel Operation Alarms Rectifying Alarm MessagesCorrection of false alarm situations during service Battery Monitoring Test Maintenance & TestingMaintenance & Testing Battery Capacity Test Until Warranty WarrantyAPC Silcon UPS Limited Factory Warranty APC Corporate How to Contact APCHow to Contact APC APC Denmark