American Power Conversion AP7610 manual Safety and Grounding

Safety and Grounding

Read the following information before installing or operating your APC AP7610 Rack PDU:

•The Rack PDU is intended only for use with four-wire grounded connections on APC Uninterruptible Power Supplies (UPS). Do not plug the Rack PDU into a wall outlet or other device.

•This Rack PDU is intended to be installed and operated only with the provided mounting hardware.

•This Rack PDU is intended for indoor use only.

•Do not install this Rack PDU where excessive moisture or heat is present.

•Do not use extension cords or adapters with this Rack PDU.

•Check that the power cord, plug, and socket are in good condition.

•Disconnect the Rack PDU from the power outlet before you install or connect equipment to reduce the risk of electric shock when you cannot verify grounding. Reconnect the Rack PDU to the power outlet only after you make all connections.

•Install the Rack PDU so that the power plug may be disconnected for service. The socket-outlet shall be installed near the equipment and shall be readily accessible.

•Install the Rack PDU so that there is not an uneven mechanical load.

•Follow the nameplate ratings when connecting equipment to the supply circuit. Do not overload the circuits. An overload condition could put your over-current protection at risk or cause problems with your supply wiring.

•This Rack PDU contains a non-replaceable lithium coin cell battery. Do not attempt to replace the battery.

Risk of electrical shock. Use only the supplied hardware to attach the mounting brackets.

Caution

Rack Power Distribution Unit — AP7610 3