American Power Conversion AP9221X166, AP9221EXPX166 quick start manual Connecting MasterSwitch VM

Connecting MasterSwitch VM

Caution	MasterSwitch VM does not provide power protection.
	Therefore, APC does not recommend plugging the unit directly
	into any unprotected power source, such as a wall outlet.
Setting up a	1. Connect the power cord of each device you wish to connect
single unit	to the outlets on the front of the unit.

2.Connect the 10Base-T network port located on the rear panel of the controller to the network, using an appropriate cable.

3.Connect the RJ-11 port labeled To PDU on the controller front panel to the RJ-11 port labeled In on the unit, using the provided communication cable (APC part number 607- 0035A).

4.Plug the unit into a protected power source.

Continued on next page

8