American Standard Single Control Lavatory Faucet with Speed Connect Drain Cold, Fig. A, Fig. B

6 ATTACH CABLE CONNECTOR

Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A.

Your new POP-UP DRAIN installation is now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

Fig. A.

1

2

Fig. B.

1-1/4” O.D.

7 CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
closes.	1
Note: If STOPPER (2) does not open and close properly then refer
to the “troubleshooting section” of these instructions.

2

8 MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED AND MUST BE PURCHASED SEPARATELY.

Connect water supply to INLET SHANKS (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.

Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate

connectors, and COUPLING NUTS.	1
Connect 1-1/4” O.D. TAILPIECE (4) on POP-UP	COUPLING
DRAIN to “p” trap.	NUT ON FLEX
	SUPPLIES

2

FLEXIBLE

SUPPLIES

3	3/8 O.D.
	BULL-NOSE

RISERS

COUPLING

NUT WITH

FAUCET

COMPRESSION

NUT

4

FERRULE

“P” TRAP COLD

3/8 COMPRESSION

HOT CONNECTION

M968882 Rev. 1 . 3