American Standard 6063.101 Roughing-inDimensions, RECOMMENDED TOOLS Fig, Prior To Installation

Fig. 1		GENERAL DESCRIPTION:
Roughing-in Dimensions
		SELECTRONIC™
		PROXIMITY URINAL
	DETECTION ZONE	FLUSH VALVE
	400mm-800mm	Exposed Flushometer
	(15-3/4 TO 31-1/2)
72mm	FINISHED WALL	for 3/4" Top Spud Fixtures
		Exclusive, self cleaning piston-type flush
(2-7/8)	57mm
		valve with proximity operation and
	(2-1/4 MIN.)
		manual override. Operates on DC
116mm	15˚	(battery) power. Recommended
		operating pressure 35 to 80 psi. Can
(4-5/8)
		install left or right-handed. Detection
		Zone can also be adjusted manually, or
		with optional remote control.
MANUAL
OVERRIDE
BUTTON	SUPPLY	Right or Left Hand Installation
	DN 19mm
	(3/4” I.P.S.)
		See (Section 5) for converting Flush
115mm-134mm		Valve to Left Hand Installation.
(4-1/2 TO 5-1/4)	409mm
293mm	(16-1/8)
(11-1/2)
FOR 3/4" TOP
SPUD FIXTURES

RECOMMENDED TOOLS; Fig. 2

1.Teflon Tape

2.Flat Blade Screwdriver (For adjusting Supply Stop)

3.Adjustable Wrench

4.Tape Measure

5.Hacksaw

6.Tubing Cutter

7.File

8.For Sweat Connection; Solder and Torch

9.2.5mm Hex Wrench

10.1.5mm Hex Wrench

Fig. 2
1	2			3
		4
			10'
				6
	5			8
	7		9	10

PRIOR TO INSTALLATION
Note: Prior to installing the Selectronic™Flush Valve	• Flush all water lines prior to operation (See Step 4). Dirt
the following items must be installed.	and debris can cause flush valve to run continuously.
1. Urinal	• With the exception of Supply Stop Inlet, DO NOT use
	pipe sealant or plumbing grease on any valve component
2. Drain line	or coupling!
3. Water supply line	• Protect the chrome or special finish on the Flushometer.
	DO NOT USE toothed tools on finished surfaces to install
IMPORTANT:	or service these valves. Also see “Care and Cleaning”
	section of this manual.
• All plumbing must be installed in accordance with
applicable codes and regulations.	• This product contains mechanical and/or electrical
	components that are subject to normal wear. These
• Water supply lines must be sized to provide an	components should be checked on a regular basis and
adequate volume of water for each fixture.	replaced as needed to maintain the valve’s performance.
	M968567 Rev.1.2

2