American Standard 7038.400 installation instructions Attach Cable Connector, Hot

8 ATTACH CABLE CONNECTOR

POP-UP KNOB (1) must be fully down. Fig. A.

Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. B.

Your new POP-UP DRAIN installation is now complete.

Fig. C.

Note: Tailpeice on pop-up drain is 1-1/4” O.D. Fig. C.

Fig. A.

DOWN

Fig. B.

1

2

Fig. C.

1-1/4” O.D.

9 CHECK OPERATION OF POP-UP

Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.

Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.

INSTALL DIVERTER KNOB

Push DIVERTER KNOB (1) onto HANDLE ADAPTER (2).

Push on RING (3) and tighten with SCREW (4).

Press on KNOB CAP (5).

Note: Screwdriver gap is for disassembling and should point downwards.

1

2

5

4

3

1

2

10 TEE AND HOSE CONNECTION

Insert SEAL (1) into ADAPTER (2) and tighten ADAPTER (2) to bottom of TRANSFER VALVE (3).

Install SEAL (4) into coupling nut of TEE (5) and tighten connection to ADAPTER (2).

Connect HOSE COUPLING NUTS (6) to Hot and Cold valve bodies and securely tighten.

WATER SUPPLY CONNECTION 7 6

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT

INCLUDED AND MUST BE PURCHASED SEPARATELY.

3	7a
1	26
4	Front
5	COUPLING
	NUT

3

3/8 O.D.

Connect water supply to VALVE BODIES (7,7a) with

1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.

Connect HOT water supply to inlet of left SHANK and COLD water supply to right SHANK using sealant, appropriate connectors, and COUPLING NUTS.

Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to waste outlet.

1/2" PIPE THREAD

2

FLEXIBLE

SUPPLIES

HOT

BULL-NOSE

RISERS

COMPRESSION

NUT

FERRULE

COLD

CONNECT TO

WASTE OUTLET

3/8 COMPRESSION CONNECTION

M 9 6 8 8 9 4

3