3MAKE WATER SUPPLY CONNECTIONS; Fig. 2
1.Turn off hot and cold water supplies before beginning.
2.Connect HOSE ADAPTERS (3) to wall supplies (if
required). Connect FLEXIBLE SUPPLIES (1, 2) directly to HOSE ADAPTERS (3).
3.Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold supply. Use adjustable
wrench to tighten connections. Do not over tighten.
4.Faucet supplies are 18" long from faucet base.
Note; If additional supply length is required, installer must purchase those parts separately.
Fig. 2
2
1
3
SEAL WASHER (SUPPLIED)
HOT
COLD
Important; If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking.
4INSTALL OPTIONAL MIXING VALVE; Fig. 3
For 7055.105/115 & 7056.105/115 Faucets.
Note; For complete detailed installation and operating instructions see installations instructions supplied with mixing valve. No. M968808
Fig. 3
No. M968808
Instructions | SELECTRONIC™ |
|
|
| Thermostatic Mixing Valve |
| |
| 605XTMV |
|
|
Installation | M968808 | Specications | 1 |
|
| Installation | 2 |
|
| Adjust Temperature | 3 |
|
| Service | 3 |
| Certified to comply with ASME A112.18.1M | Replacement Parts | 4 |
| © 2005 American Standard |
|
|
NOTE TO INSTALLER: Please give this manual to the customer after installation.
To learn more about American Standard Faucets visit our website at: www.us.amstd.com or U.S.
customer's
For Parts, Service, Warranty or other Assistance,
please call
(In Toronto Area only:
MAINTENANCE | Fig. 1 |
1HANDWASH SENSOR OPERATION; Fig. 1
REMOVE PROTECTIVE FILM FROM SENSOR EYE
WHEN INSTALLATION IS COMPLETE.
When the Sensor detects a user, the water immediately starts to flow. Water flow will stop two seconds after user is out of sensor range. The off delay allows the user to comfortably move his hands without the flow cycling on to off. As a precaution, a safety timer will turn off the water, after the sensor has been blocked for 59 seconds. The water will stay off until the blockage is removed from the detection zone.
Detection Zone: 2" - 10" (50.8mm - 254mm)
Default: Set at Factory 6" (152.4mm)
DETECTION ZONE
PROTECTIVE FILM
3 | M965255 REV. 1.6 |
|