American Standard 705.215, 7055.105 Installation, Roughing-in Dimensions, Tools Required Fig

Roughing-in Dimensions

Fig. 1

191mm

FINISHED WALL OR BACKSPLASH

(7-1/2)

MIN. 1" CLEARANCE

191mm

(7-1/2)

165mm

140mm (6-1/2) (5-1/2)

66mm

MOUNTING SURFACE

38mm

(1-1/2 )

457mm

(18)

3/8" COMPRESSION

CONNECTORS

( 2-5/8)

32mm (1-1/4)

GENERAL DESCRIPTION:

Electronic faucet with proximity operation. Vandal resistant solid brass construction single post mounting. Operates on DC (battery) or AC power. Inlets 3/8" compression, built-in checks, flexible stainless steel 18" reach inlet hoses for spout connection and In-line integral strainer for solenoid.

TOOLS REQUIRED; Fig. 2

1	Hex Wrench (Included)	4	Phillips Screwdriver
2	Adjustable Wrench	5	Tape Measure

3Plumbers' Putty or Caulking

INSTALLATION

1INSTALL SPOUT ASSEMBLY;

Fig. 1 CAUTION	Turn off hot and cold water
	supplies before beginning

1.Make sure O-RING SEAL (9) is installed.

2.Installation with ESCUTCHEON (1) (optional). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1). (Only if mounting surface is uneven).

3.Insert supply HOSES (2), SHANK (3) and POWER CORD

(10)(if equipped) through hole in ESCUTCHEON with PUTTY PLATE (1) and mounting surface. Follow mounting instructions below to secure faucet to mounting surface. (Make sure PIN (7) is in back).

4.Installation less ESCUTCHEON (1). IMPORTANT: Do not use putty when installing faucet without escutcheon.

5.Assemble RUBBER WASHER (4), BRASS WASHER

(5)and THREADED LOCKNUT (6) onto SHANK (3) from underside of sink or mounting surface. Hand tighten LOCKNUT (6).

6.Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the screws slightly each time until all are snug to ensure even pressure.

2CONNECT POWER SUPPLY; Fig. 1a (7056 series only)

1.Connect the sensor cable (1) to the POWER SUPPLY CABLE (2).

2.Code approved Electrical Outlet provided by others. (120V 50/60 Hz)

3.Plug AC POWER SUPPLY (3) into Outlet.

Fig. 2	1
		2
3
	4	5	10'

Fig. 1

	IMPORTANT: Do not
	use putty when installing
	faucet without escutcheon.		7
	PUTTY	9
	(If required)
		3		1 (OPTIONAL)
Fig. 1a		10		MOUNTING
				SURFACE

2	TIGHTEN
	SPIN NUTS

4

5 8

1 6 2

3

ELECTRICAL OUTLET (120V 50/60 Hz)

2 M965255 REV. 1.6