Amtrol WELL-X-TROL, WELL-X1 warranty Plumbing, Water Connections Check Valve

6. PLUMBING

1.Plumbing connections are similar to a traditional "tank cross" or "tank tee". Provisions are made for popular line sizes via a 1-1/4" NPT male outer thread and a 1" NPT female inner thread. The plumbing connections are not directional and allow flow from either side. When attaching valves or fittings, uses the wrench flats provided.

EXPLOSION HAZARD. Failure to follow these instructions can cause a rupture or explosion possibly causing serious or fatal injury, flooding, and/or property damage.

2.Install the supply piping from the well pump. If required, install a spring-loaded check valve.

3.Install a shutoff (service) valve on the outgoing line. This will allow the Well-X1™to be tested prior to pressurizing the entire system. DO NOT place a shutoff on the incoming supply line.

NOTE: The relief valve is sized for a maximum flow rate of 10 gpm at 125 psi. If the pump installation allows higher flow rates, an additional relief valve must be installed.

WATER CONNECTIONS

CHECK VALVE

6