AMX NXP-CPI16 manual Lvlsz

Send_Commands (Cont.)

LVL_SZ	The default is byte (8-bits), which yields a range of 0 - 255 for the level value.
Sets the size (data	Syntax:
type) of the value	‘LVL_SZ <level #> <data type of level value>’
that will be used by
	Variables:
the NXP-CPI16
when receiving	Where <level #>
and sending	1 - Quadrature Input 1
LEVEL messages.	2 - Quadrature Input 2
	3 - Bargraph 1 (using outputs 1 - 8)
	4 - Bargraph 2 (using outputs 9 - 16) and <data type of level value>
	B - Byte (8-bits); range of 0 - 255 [default level data type]
	I - Integer (16 bits); range of 0 - 65,535
	S - Signed Integer (signed 16-bits); range of -32,768 to 32,767
	Example:
	SEND_COMMAND ’LVL_SZ 2 S’
	Quadrature Input 2's data type is now Signed Integer.
STATUS-OFF	Syntax:
Puts the NXP-	‘STATUS-OFF’
CPI16 in Default	The CPI16 remembers the last Mode it was set for. Therefore, once a ’STATUS-OFF’
Mode (non-Dis-
	Send_Command is received, Default Mode becomes the power-up mode of the CPI16. It
crete Output
	is not necessary to send a ’STATUS-OFF’ Send_Command each time the device is pow-
Mode).
	ered. Once the CPI16 is programmed for Default Mode, it remains in that mode until a
	’STATUS-ON’ Send_Command is received; see chart below.
	Inputs 1 - 8		Channels 1 - 8 (Push/Release only)
	Outputs 1 - 8		Channels 1 - 8 (On/Off only)
	Inputs 9 - 16		Channels 9 - 16 (Push/Release only)
	Outputs 9 -16		Channels 9 - 16 (On/Off only)
	It is not necessary to send a 'STATUS-OFF' Send_Command each time the device is
	powered. Once the CPI16 is programmed for Default Mode, it will remain in Default
	Mode until a 'STATUS-ON' Send_Command is received.
STATUS-ON	Syntax:
Puts the NXP-	‘STATUS-ON’
CPI16 in Discrete	The CPI16 remembers the last Mode it was set for. Therefore, once a ’STATUS-ON’
Output Mode.
	Send_Command is received, Discrete Output Mode becomes the power-up mode of the
	CPI16. It is not necessary to send a ’STATUS-ON’ Send_Command each time the
	device is powered. Once the CPI16 is programmed for Discrete Output Mode, it remains
	in that mode until a ’STATUS-OFF’ Send_Command is received.; see chart below.
	Inputs 1 - 8	Channels 1 - 8 (On/Push/Off/Release)
	Outputs 1 - 8	Channels 9 - 16 (On/Off only)
	Inputs 9 - 16	Channels 17 - 24 (On/Push/Off/Release)
	Outputs 9 -16	Channels 25 - 32 (On/Off only)

NXP-CPI16 NetLinx Custom Panel Interface 7