NXP-CPI16 Specifications

Specifications

Power Requirement	12 VDC (300 mA max.)

Input Connectors:
Indicator Power	Two-pin 3.5 mm captive-wire. This connector is used to supply a higher voltage
	and more current to the power pins of Header 1 and Header 2. The external
	supply connected to the two-pin captive-wire must be greater than +12 V. If the
	external supply voltage is less than that, the ICSNet supply (+12 V) will be
	used for the Power pin of the I/O connectors (not the external supply).
Closure Inputs
Closure Inputs	16 closure inputs activated with a GND or TTL Low (< 0.8 V). Inputs are sam-
	pled approximately every 10 msec and are debounced in software.
Rotary Encoder Inputs
Rotary Encoder Inputs	2 quadrature inputs on a 2 x 3 header with a +5 V supply pin (supplying up to
	100 mA) and a GND pin.

ICSNet	2 RJ-45 connectors for ICSNet connection

ID Button	Generates an event from the CPI16 to allow you to assign new Device num-
	bers, using ID mode in the NetLinx Studio software program.

LED	ICSP status indicator (green)

Open Collector Outputs	16 open-collector outputs, acting as a switch to ground, up to 100 mA. Outputs
	can be connected to voltages ranging between 0 V and +28 V. Each output is
	updated approximately every 10 msec.

Dimensions (HWD)	2.75" x 1.75" x 0.062" (69.85 mm x 44.45 mm x 1.557 mm)

Weight	8.10 oz (229.6 g)

Accessories	• 6-pin header with 3 feet (0.91 m) of ribbon cable
	• Two mating 20-pin headers, each with 3 feet of ribbon cable attached
	• One green 2-pin 3.5 mm pitch captive wire connector for external indicator
	power.

2	NXP-CPI16 NetLinx Custom Panel Interface