Breadboard Area
Switch (SW1)” on page 2-3. The setup of the general-purpose signals DAI_P15_GP1 and DAI_P16_GP2 is dependent on the specific ADC HSC evaluation board being interfaced; therefore, the board’s model must be taken into consideration.
The data bus of the EZ-Extender must be enabled before data is read. Enable the data bus by a memory read from address 0x160 0000, which the AD[15:0] pins set up as the external port. Then, the AD[15:0] pins can be set up in PDAP mode.
A list of ADC boards compatible with the extender can be found at
http://www.analog.com/processors/processors/blackfin/technicalL- ibrary/manuals/pdf/EZ-Extender_to_DSP_Supported.pdf. Contact
Technical Support for information about available examples. To learn more about Analog Devices data converters, go to www.analog.com.
Breadboard Area
SHARC EZ-Extender broadens the range of the EZ-KIT Lite applications by providing surface mounted (SMT) footprints for breadboard capabili- ties and access to all of the pins on the EZ-KIT Lite’s expansion interface.
1-2 | SHARC EZ-Extender Manual |
