Anetsberger Brothers FFM-150, FFM-80 Installation Instructions, Filter Electrical Specifications

INSTALLATION INSTRUCTIONS

FILTER ELECTRICAL SPECIFICATIONS

Please make sure that your desired filter location has electrical supply factors that are suitable for this product. Requirements are 120 Volts, 60 Hz, 8 Amps, 1-phase,three-wire connection, including an electrical ground. This unit is not fused. Protect circuit with proper sized fuses or circuit breaker. Line disconnect switch, circuit breaker, or plug and receptacle of power cord connection should be readily accessible to the operator.

!

WARNING

!

Electrical Grounding Instructions

This appliance is equipped with a three-prong (grounding) plug for

your protection against shock hazard, and should be plugged

directly into a properly grounded, three-prong receptacle. DO NOT

cut or remove the grounding prong from this plug.

FILTER UNIT PREPARATION (Refer to Photos On Page 4)

1.Assemble filter envelope to filter screen by sliding the envelope over the filter screen, folding back the open end over the filter screen. Make sure the hole in the filter envelope fits over the fitting on the filter screen.

WARNING

Only use filter paper envelopes from Anetsberger Brothers that have been specifi- cally designed for this filter system. Using the wrong type of filter paper can cause damage to the pump system, and will void the Warranty

2.Assemble filter envelope clip over folded back end of envelope and over fitting on filter screen.

3.Attach knurled retaining nut onto fitting on screen, securing the assembly.

4.Attach quick-connect coupling located on drain tube to knurled retaining nut.

5.Place filter unit into the filter tank.

6.Connect the filter assembly to the pump using the quick-connect assembly.

7.Put the filter tank cover on the tank.

8.Connect the hose assembly to the filter pump.

3