Antec TX1050B Specifications, Front 80mm fan mounts, VGA Card Cooling, Air Guide Adjustment

Specifications:
Size:		120 x 120 x 25.4 mm
Rated Voltage:		DC 12V
	Speed	Input	Air Flow	Static	Acoustical	Input
		Current		Pressure	Noise	Power
	High	0.24A	2.24 m³/min.	2.54 mm-H2O	30 dBA	2.9 W
	2000 RPM	(Max.)	(79 CFM)	(0.10 inch-H2O)
	Medium	0.2A	1.59 m³/min.	1.53 mm-H2O	28 dBA	2.4 W
	1600 RPM		(56 CFM)	(0.06 inch-H2O)
	Low	0.13A	1.1 m³/min.	0.92 mm-H2O	25 dBA	1.6 W
	1200 RPM		(39 CFM)	(0.04 inch-H2O)

This case comes with two 80mm front fan mounts, one 80mm side panel fan mount for the VGA card and one 92mm fan mount in the lower chassis air guide for the CPU. These are optional fan locations, to install fans please read the following directions.

•Front 80mm fan mounts

There are two plastic fan cages. One of them is located inside the 3.5" drive cage to cool your hard drives directly. You should install this fan before you mount your HDD drives into the cage. The 2nd fan mount is located underneath the internal 3.5"

drive cage. Install both fans by dropping the fan into the cage and push it until it snaps in. These fans must be installed so that the air is blowing into the case. Connect a large 4-pin connector from the power supply to the male 4-pin connector on each of the fans. We recommend using Antec 80mm TriCool fans to balance quiet performance with maximum cooling. Note: Please choose your fan speed wisely. In most cases, a medium or even low speed setting will be enough to supply adequate cooling.

•VGA Card Cooling

There is an 80mm fan mount with vents on the side panel right above the VGA card. The vents can supply fresh air to the card without a fan (passive cooling), or with a fan (active cooling) if you are using a high performance VGA card that needs extra cooling. Install the fan so that the air is blowing into the case. We recommend using Antec 80mm TriCool fan.

•CPU Cooling – Chassis Air Guide

Your case includes a special chassis air guide and vents for improved cooling of your CPU. The air guide consists of two parts: an upper duct with flange and a lower duct with a 92mm fan hood. The air guide is designed to work with different CPU configurations.

•Air Guide Adjustment

There is a square vent area on the side panel corresponding to the CPU area. The air guide comes pre-installed according to Intel's recommended CPU location. However since not all motherboards follow the exact recommendation, you may need to adjust the air guide to match your CPU position.

Normal Mode

1.Remove the four mounting screws that fasten the upper air guide flange to the side panel.

2.Move the upper guide flange within the square vents area so that the lower duct hood will cover the entire CPU cooler.

3.Fasten the upper air guide to the side panel once you have aligned the hood with the CPU.

4.Loosen the thumb-screw that fastens the lower air guide to the upper air guide and lower

6