2
Set the board number with jumpers as shown below. If only one
board is being used, leave the jumpers off (sets to board number
one). When using more than one card in a computer, each board
must be given a different number by setting the jumpers differ-
ently on each card. Any model Antex Card may be used with any
other model Antex Card. All model Antex Cards use the same
jumper arrangement to set the board number.
JUMPER SETTINGS & CONNECTIONS
Top View
Board 1 Board 2 Board 3 Board 4
Covered by jumper
J1
SX-5e/6/3435/36
2
14
32
14
3
2
14
32
14
3
Figure 1. SX-5e,6,34,35 & SX-36 Jumper Settings
The jumpers are oriented vertically so that they may be easily
changed without having to remove the card from the computer
slot if they should need to be changed later. These jumpers only
set the board number, allowing for more than one board in a com-
puter. They do not set interrupts.