3.SETUP continued …

After highlighting Power or a source, press SELECT and use the ￿￿buttons to move from one path to another. To set the condition, use the ￿￿ buttons to change the “–” to a “*”. Don’t forget: In the root menu you have to set ALL TRIGGERS to Enabled for the triggers to work.

Changes to the trigger setup do not take effect until exiting from the setup menu, to avoid unnecessary rapid turning off and on of triggers while making changes.

Example: Activate Trigger2 when DVD1 is selected in MAIN.

•Enter the setup menu. Go to TRIGGER / IR / RS232 and press SELECT.

•Upon entering this menu item, ALL TRIGGERS will be highlighted in red.

•Use the ￿￿buttons to change to Enabled.

•Press the ￿ button to go to SET TRIGGER 2. Press SELECT.

•Use the ￿￿ buttons to go to DVD1. Press SELECT.

•Use the ￿￿ buttons to change the “–” to “*”.

•Press BACK twice to leave this submenu.

Set IR Inputs:

This allows you to enable or disable the processor’s infra-red inputs. Being able to do so can be useful when an IR receiver, connected to the processor, is located in the same room as the processor. In such a case, the processor can receive two IR signals for the same command – one through the front, and one through the back. The potential result is that whatever you’re trying to command may not respond. Disabling the front IR solves this problem.

The IR signal may also leak into the unit through the vents in the top cover, which could also cause IR commands to be intermittent or ineffective. If the rear IR inputs are not in use, try disabling them.

 

 

 

11e. SET IR-INPUTS

 

 

a. FRONT IR:

MAIN Z2 Z3

*

*

*

b. REAR IR 1:

*

*

*

c. REAR IR 2:

*

*

*

d. REAR IR 3:

*

*

*

 

 

 

 

After highlighting an IR input, press SELECT and use the ￿￿buttons to move from one path to another. To turn the input off, use the ￿￿ buttons to change the “*” to a “–”. Do this through the front panel, since remote control commands are ineffective once an IR sensor is turned off.

If the processor does not respond to remote control commands, enter the Setup using the front panel buttons, go to the TRIGGER / IR / RS232 menu then SET IR-INPUTS, and make sure the FRONT IR settings are set to “*”. Try this before contacting technical support (see also section 5.6).

Baud Rate and Flow Control (normally for use only by custom installers):

The Baud Rate (adjustable from 1200 to 115200 bps), and Flow Control (RTS, CTS, or None), allow configuration of the serial port communication parameters.

RS-232 TX Status (normally for use only by custom installers):

When On, all commands, status changes, and control information are echoed through the RS-232 port.

41