Antunes, AJ VCT-20, VCT-50, VCT-25 owner manual Operation, Operating Instructions

VERTICAL CONTACT TOASTER

OPERATION

Operating Instructions

1.Set the bun adjustment controls (Figure 6) to the desired settings.

NOTE: After initial run of 4-6 buns, adjust controls according to the desired finished product.

2.Turn the rocker switch on (Figure 5).

3.Turn the temperature control to 10. Allow 30 min- utes warm-up time before proceeding.

4.Drop buns into toaster (Figure 5). Cut sides of heel and crown must face each other.

5.Toasted product will drop into the bun landing area (Figure 5).

6.Test at least 4 buns before putting toaster into service. Turn temperature control to lower setting for lighter toasting or to higher setting for darker toasting.

7 Turn the rocker switch off when finished toasting

Safety Features

HI-LIMIT RESET BUTTON

Bun Thickness
Adjustment Controls
(see Figure 6)
	3		6		Hi-Limit Reset
2	4	5	1
1		4
	5		2
	6		3
					Temperature Control
Bun Landing				Rocker Switch
	Area

A hi-limit thermostat will turn off electrical power to the heater and control circuits if the unit overheats. To reset this thermostat, allow sufficient time (10-15 min- utes) for the unit to cool down, then fully depress the reset button located at the rear of the unit (Figure 5).

If the unit requires continuous resetting, contact your Roundup authorized service agency.

CONVEYOR INTERLOCK SWITCH

A conveyor interlock switch is located on top of the unit under the heat shield (Figure 4). The conveyors will not rotate unless the heat shield is in place and interlock switch is activated (depressed).

Figure 5. Toaster Controls

3	THICKNESS				THICKNESS		6
2						5
		4					1
1		1 =		1/2"(12.7mm)		4
		2 =		5/8"(15.9mm)
	5	3 =11/16"(17.5mm)					2
		4	=	3/4"(19.1mm)
		5	=13/16"(20.6mm)				3
6		6	=	7/8"(22.2mm)

Figure 6. Bun Thickness Adjustment Controls

P/N 1010729 Rev. C 05/04 9