Antunes, AJ VS-200aSb owner manual Variety Steamer

		Variety Steamer
	Troubleshooting (continued)
Problem	Possible Cause	Corrective Action
Unit heats but there is little	Insufficient or excessive calcium/mineral	Verify that a thin layer of calcium/mineral
or no steam produced	buildup on generator surface.	deposits is present on the Generator sur-
and/or		face. Refer to the Maintenance section of
		this manual.
The product requires more	Black Manifold O-ring is worn, damaged,	Replace the Black Manifold O-ring if worn,
steaming than usual.	or missing.	damaged, or missing.
(Continued)	Low Generator temperature.	Verify Generator surface temperature is at
		least 380° F (193° C),
Steam leaks out of the	Black Manifold O-ring is damaged or	Replace the Black Manifold O-ring if worn,
sides of the unit.	missing.	damaged, or missing.
Black Manifold is difficult	Black Manifold not being removed and	Remove and Clean the Black Manifold
to remove or re-install	cleaned daily as required.	Daily according to the Maintenance section
onto the Generator.		of this manual.
	Black Manifold O-ring is damaged or	Replace the Black Manifold O-ring if dam-
	worn.	aged or worn.
	Black Manifold O-ring is not being lubri-	Lubricate the Black Manifold O-ring daily
	cated daily with Petro Gel.	according to the Maintenance section of
		this manual.
Unit floods over night	Solenoid valve is being held open by	Attempt to flush the debris out of the valve
and/or continues to steam	debris from the building’s water line pip-	by operating the unit on a number of cycles
even when just in ready	ing.	and then letting it rest. If the unit still
mode.		leaks, contact your maintenance person or
	There is no pre-strainer/filter on the water
	line just before the unit.	Authorized Service Agency.

P/N 1010649 Rev. E 03/07 17