Antunes, AJ VS-200aSb owner manual Troubleshooting, Problem Possible Cause Corrective Action

Variety STeamer

Troubleshooting

Warning

To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests. Live circuits will be exposed.

Problem	Possible Cause	Corrective Action
Power On/Off switch is	The power cord is not correctly plugged	Plug the power cord in correctly.
turned on, but the Switch	in.
Indicator Light is still off
	The power cord and/or electrical plug is	Inspect electrical wire, plug, and recep-
and the unit is not heating	damaged.	tacle.
up.
	The main electrical panel circuit breaker	Reset circuit breaker. Contact your main-
	is off, or has been tripped.	tenance person or Authorized Service
		Agency if it trips again.
	Switch is inoperable.	Contact your maintenance person or
		Authorized Service Agency for service.
The unit’s main electrical	Damaged receptacle, plug, or cord; a	Turn the unit off, allow it to cool to room
panel circuit breaker trips.	loose connection or an internal compo-	temperature, and then restart the unit.
	nent failure.	Contact your maintenance person or
		Authorized Service Agency if condition
		repeats.
Power On/Off switch is	Hi-Limit thermostat is tripped.	Reset the Hi-Limit according to the
turned on, the switch indi-	Inoperable Thermostat.	Operation section of this manual. If it
cator light is on, but the		requires continuous resetting or repair,
	Inoperable Generator.
unit is not heating up.		contact your maintenance person or
	Loose/burnt wiring.
		Authorized Service Agency for service.
Unit heats but there is lit-	Water Line valve is closed.	Check that the Water Line Valve is open.
tle or no steam produced
	Filter Strainer is restricted.	Check and clean the Filter Strainer as
and/or		described in the Maintenance section of
		this manual.
The product requires more	Quick Disconnect is not fully engaged at	Remove and re-engage the Quick
steaming than usual.	rear of unit or is damaged.	Disconnect Insert firmly until a “click” is
		heard. Replace if damaged.
	Low or no water pressure in water line.	Remove the Quick Disconnect Insert from
		the rear of the unit. While holding over a
		bucket, press the “white” plastic tip. Strong
		Water flow should be noted. If so, recon-
		nect firmly into unit. If
	Spray Tube is restricted.	Remove and clean the Spray Tube accord-
		ing to the Daily Maintenance procedures
		found in this manual.
	Black Manifold orifices are restricted.	Remove and clean the Black Manifold
		according to the Daily Maintenance proce-
		dures found in this manual.
	Unit is not being cleaned daily and/or	Clean unit Daily according to the Daily
	properly.	maintenance procedures found in this
		manual.
	Improper water pressure to unit.	Verify that a Water Pressure Regulator is
		installed and set to 20-25 PSI.
	16	P/N 1010649 Rev. E 03/07