ANUBIS Wireless Access Point instruction manual Switches and Connectors

Typhoon Speednet Wireless Access Point

Switches and Connectors

Nodes with a Cirrus wireless adapter installed can be switched from Wi-Fi to Multimedia mode (and vice versa) using the device manager software. As the Access Point (AP) does not have a user interface that can be used to switch between multimedia and Wi-Fi, it employs a manual mode switch. This switch can be found on the AP and is labeled accordingly.

Depending on the configuration of your evaluation kit you may have received one of three Access Points (AP). All APs offer similar functionality but vary in appearance. The below installation instructions apply to all available APs.

•Mode Switch

-Used to switch between Multimedia (WhiteCap) and Wi-Fi mode.

•Factory Default Reset

-Used to reset all parameters (i.e. SSID, WEP etc) to the factory default.

•Reset

-Used to reset the AP. (similar to power cycling)

•Power

-Connects to (included) power adapter.

•WAN Port

-Connects to HUB, router, cable/DSL modem for LAN / Internet connectivity.

•LAN Port (not available on all APs)

-Can be used to connect a wired client node to the network.

•USB Port

-Connects to connector, use for configuration only. (AP Manager software required)

15