To install a sensor on the vertical rail of an APC rack:

1 . Determine a location on the vertical rail that will allow you to route and secure the 4-m (13-ft) cord neatly.

aem0184a

2 . Peel the backing off the adhesive side of a sensor mount, and press the cable mount firmly to the vertical rail.

3 . Thread a tie wrap through the sensor mount.

4 . Secure the sensor to the sensor mount with the tie. Tighten and trim the tie wrap.

5 . Thread the sensor cord through the opening in the front post of the rack.

6 . Route the cords between the vertical support rail and the side panel. Each sensor cord may be extended to a maximum of 15 m (50 ft), using RJ-45 couplings and standard CAT5 cables.

10 Environmental Manager: Main Module

Page 14
Image 14
APC AP9340 manual To install a sensor on the vertical rail of an APC rack