Installation—Main Module

You can install the Main Module in the front or the rear of the rack or enclosure, using either the rack-mount option, which uses 1 U of rack space, or the toolless peg-mount option, which does not use any U-spaces. (The toolless peg-mount option is available only with APC NetShelter® VX and SX racks and enclosures).

Toolless peg-mount installation

1 . Slide both mounting pegs into the holes located in the cable channel in the rear panel of the rack.

2 . Snap the Main Module into place by pushing it downward until it locks into position.

aem0049a

Rack-mount installation

1 . Remove the toolless mounting pegs located at the front of the unit.

2 . Attach the brackets (provided) to each end of the Main Module, using two screws for each bracket.

3 . Choose a location in the rack for the Main Module.

Note: The Main Module occupies one U-space. A notched hole (or a number, on newer racks) on the rack’s vertical rail denotes the middle of a U-space.

Environmental Manager: Main Module

5

Page 9
Image 9
APC AP9340 manual Installation-Main Module, Toolless peg-mount installation, Rack-mount installation