Complete Performance Verification. Refer to Initial Startup in the CTFLM/CTSLM User Manual 990-5501.

Replace/close the enclosure door(s).

Indicator Lamp Replacement

Gently pry the lens off the indicator lamp using the tip of a screwdriver.

NOTE: Place a hand over the lens as it is loosened to ensure that the lens is not lost during the procedure.

Remove the spent lamp and replace it with a new one.

Snap the lens back into place.

Euro Block Replacement

Switch the utility circuit breaker OFF.

Remove/open the enclosure door(s).

Remove the CTFLM.

Disconnect (and tag), the wiring harness and utility wires from the Euro block.

Remove the screws that secure the Euro block in the enclosure, and lift out the Euro block.

Insert the new Euro block and secure it in the enclosure.

Reconnect the wiring harness to the Euro block.

Reinstall the CTFLM.

Replace/close the enclosure door(s).

Switch the utility circuit breaker ON.

Complete Performance Verification. Refer to Initial Startup in the CTFLM/CTSLM User Manual 990-5501.

11

Page 13
Image 13
APC CTSLLP/G user manual Indicator Lamp Replacement, Euro Block Replacement