Apple 073-0841 - page 10

Power Mac G4 Cube Optical Drive - 10
2. Install the connector board on the replacement optical drive, and secure it to the drive
with the two screws. (Figure 13)
Figure 13
3. Holding the optical drive case by one corner, position the drive over the chassis so the
labeled panel faces out and the connector board is at the bottom of the drive case.
Slide in the drive half way and connect the power cable and the ATA ribbon cable.
4. Slide the drive all the way down and ensure the screw holes align on both sides of the
drive. If they do not align, reseat the connectors. (Figure 14)
Figure 14