The network printer keeps restarting.
mSomeone on the network may be using a version of printer software that is
different from the version used by others on the network. Everyone
connected to a network should use the same printer software version.
Consult the network administrator for more information.
Nothing happens, or you see an error message, when you try to print.
mThe printer may not be selected in the Chooser. Open the Chooser and
reselect the printer.
mThe printer may not be turned on. Make sure it is plugged in, turned on
and warmed up.
mThe printer may be out of paper or have some other problem. Check the
printer status lights and any messages on your screen.
mIf an error message states that the printer could not print your document,
turn the printer off for at least 10 seconds. Then turn it on again, wait for it
to warm up, and try to print again.
Your documents are printed with the wrong fonts.
mThe printer may not have your fonts in its memory and may be substituting
other fonts. You may be able to add the necessary fonts to your printer (see
the Macin tosh Referencebook for instructions), or print on a different
printer that has the fonts you want. If you have a LaserWriter printer, you
can turn off Font Substitution in the Page Setup dialog box.
See the Macint osh Reference book for general information about printing
documents. See your printer manual for more information about your
printer’s features or problems with the printed output.
123
Tips and Troubleshooting