Manuals / Apple / Computer Equipment / Computer Hardware

Apple Front Panel Board Cable warranty Closing the Computer, Hard Drive, Replace access panel

Models: Front Panel Board Cable

1 14

Download 14 pages 52.63 Kb

Page 14

Image 14

Hard Drive

16 Replace hard drive in

far-left drive bay.

Closing the

Computer

1Replace access panel.

Note: Make sure latch is up before you replace panel. If latch is down, panel will not seat correctly.

2Push latch down to close and secure access panel.

Warning: Never turn on computer unless all its internal and external parts are in place and it is closed. Operating computer when open or missing parts can cause damage or injury.

Apple Inc.

This document is protected under U.S. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple.

Apple is not responsible for typographical, printing, or inadvertent errors. Apple Inc.

1 Infinite Loop

Cupertino, CA 95014-2084 USA

+1 408 996 1010 www.apple.com

Apple, the Apple logo, and Mac are trademarks of Apple Inc., registered in the U.S. and other countries.

073-1257 Rev. A 14

Page 14

Image 14

Apple Front Panel Board Cable warranty Closing the Computer, Hard Drive, Replace hard drive in far-left drive bay

Contents

Replacement Instructions First StepsOpening the Computer Front Panel Board CableRemoving the Installed Cable Required ToolsHard Drive 5 Remove bracket from enclosure Graphics Card3 Locate graphics card in slot 073-1257 Rev. A 6 Press button on PCIe fan 7 Move fan to left, which releases retention barChecklist for handling card 073-1257 Rev. A Processor Tray10 Locate processor tray 12 Holding tray by latches, lift it out of computer PCIe Fan13 Place tray DIMM side up on soft, clean cloth 14 Locate PCIe fan17 Locate processor cage Processor Cage15 Remove 2 screws 16 Slide fan up and out of computer 073-1257 Rev. A 19 Using long-handled Phillips #1 screwdriver, loosen 6 captive screws 073-1257 Rev. A Front Panel Board Cable24 Lift cage out of enclosure 26 Disconnect cable from front panel board and backplane board Installing the Replacement Cable1 Connect replacement cable to front panel board and backplane board 27 Remove cable from enclosure2 Position cage in enclosure Processor CagePCIe Fan Graphics Card 12 Reinstall graphics card in slotProcessor Tray Slide PCIe fan to the right to lock card in placeHard Drive Closing the Computer1 Replace access panel 16 Replace hard drive in far-left drive bay