Apple ZM034-4942-A manual Getting the Best Sound, Cleaning or Replacing the Mesh Caps, English 3

Using Apple In-Ear Headphones with Remote and Mic

Congratulations on purchasing the Apple In-Ear Headphones with Remote and Mic.

To use the headphones, plug them into your iPod or iPhone and insert the headphones in your ears. The remote and mic are supported by:

ÂÂ iPod nano (4th generation) ÂÂ iPod classic (120GB)

ÂÂ iPod touch (2nd generation) ÂÂ iPhone 3G S

To	Do this
Play or pause a song or video	Press the center button once. Press again to
	resume playback.
Skip to the next song or chapter	Press the center button twice quickly.
Go to the previous song or chapter	Press the center button three times quickly.
Answer or end a call	Press the center button once to answer.
	Press again to end the call.
Decline an incoming call	Hold down the center button for about two
	seconds, then let go. When you let go, two low
	beeps confirm you declined the call.

Switch to an incoming or on-hold call and Press the center button once. Press again to switch

put the current call on hold	back to the first call.
Switch to an incoming or on-hold call and	Hold down the center button for about two
end the current call	seconds, then let go. When you let go, two low
	beeps confirm you ended the first call.
Increase volume	Press the ∂ button.
Decrease volume	Press the D button.

Getting the Best Sound

Getting the best sound with your Apple In-Ear Headphones with Remote and Mic requires using the eartips that provide the best seal. Try all three sizes (S, M, L) in each ear and choose the ones that fit snugly and comfortably in your ear canal, like a pair of earplugs. When the fit is right, most outside noises are blocked and music has a rich bass sound.

Cleaning or Replacing the Mesh Caps

The mesh caps protect the headphone speakers from damage. If the mesh caps become clogged with earwax or the sound becomes muffled, clean or replace them (an extra pair is included). To clean the mesh caps, first remove the silicone eartips, then unscrew the mesh caps from the headphones. Soak the mesh caps in very hot tap water with a drop of dish soap for 30 minutes. When the wire mesh is completely unclogged, rinse with cool water and dry thoroughly before screwing them securely back onto the headphones and replacing the silicone eartips.

WARNING:  Do not use the headphones without the silicone eartips. Before attaching eartips, make sure the mesh caps are securely attached.

English   3