TABLE OF CONTENTS
General Installation |
|
| 2 |
Specifications: | A | SM50EZ | 4 |
| B | 5 | |
| C | 6 | |
| D | 7 | |
SM50EZ | Parts List & Exploded View | 8 | |
| Wiring Diagram | 9 | |
| Parts List & Exploded View | 10 | |
| Wiring Diagram | 11 | |
| Parts List & Exploded View | 12 | |
| Wiring Diagram | 13 | |
| Parts List & Exploded View | 14 | |
| Parts List & Exploded View | 16 | |
| Parts List & Exploded View | 18 | |
| Wiring Diagram | 20 | |
Warranty |
|
| 22 |
GENERAL INSTALLATION
1.Always clean equipment thoroughly before use. (See general cleaning instructions.)
2.Check rating label for your model designation & electrical rating.
3.For best results, use stainless steel counter tops.
4.All dimensions in parenthesis in centimeters unless noted.
1. nstall PIN 54508, brass fitting in each end of the solenoid using Teflon tape (not supplied).
2. Wrap the threads of the fitting as shown in the figure NO.1.
3. Remove the nut from the brass fitting and the sleeve from the inside of the fitting.
4. Place the sleeve and the nut, nut first, over the W copper tubing, PIN 54578, supplied with the equipment.
5. nstall the line into the solenoid and tighten the nut finger tight.
6. Using a wrench, tighten the nut far enough to crush the sleeve and attach the line. NO E: Do not over tighten nut. Just enough pressure is required to stop water leaks.
7. nstall the 3/8 x 1/4 adapter to the 3/8 stainless steel tube fitting using Teflon tape as shown in figure NO.2.
8. Using the other end of the copper tube, install the line, nut, and sleeve to the adapter.
9. Tighten using the same procedure as before.
10. Turn on water supply and look for leaks. If any leaks are found, tighten the nuts until leak is stopped. NO E: With
INSTALLATIONLLATION INSTRUCTIONS FOR EZ WELL SUPPLY LINE
2