assembly instructions
Since your elliptical cross trainer is a heavy piece of equipment, we recommend that you use 2 people during assembly.
STEP 1: Secure Frame (See Figures 1 & 2)
A.Place the cross trainer on the floor in a level area. Pull out the chrome plated rails by grabbing the back of the rails, by the rear feet, and pulling the rear feet away from the frame. The rails need to be fully extended in the length before the nuts ca be attached.
Note: These rails pushed into the frame to reduce the shipping size.
B.Secure the rails in place using the 4 Nuts (K) with Lock Washers (M) included in the hardware bag.
C.Tighten the 4 Nuts (K) with Lock Washers (M) using the provided wrench.
STEP 2: Attach Handlebars (See Figure 3)
A.Attach both the right and left handlebars by first removing the four attaching screws (J) already in place on the frame brackets where the handlebars are mounted. Place the handlebar bracket over the top of the frame bracket and align the 4 holes. Hand tighten each of the 4 screws (J) first before tightening with the provided 6 mm Allen wrench.
B.Attach the round plastic outside handlebar covers by first removing the screws (L) that are hand tightened on the inner round cover. Place the outer cover over the inner cover, aligning the holes, and install and tighten the
2 screws (L) with a Phillips head screw driver.
| STEP 3: Attach the Display Console Frame (See Figure 4) |
| |
Screws Already in Place on the Elliptical | A. Remove the 4 screws (J) hand tightened into the top of |
| the console mount bracket. With the help of a 2nd person |
| connect the connector between the main frame and the |
| display console frame. |
Hardware Bag
8 |
B.Align the Display Console Frame over the Main Frame bracket being careful not to pinch the wire harness between the 2 frames. Install and hand tighten the
4 attaching screws (J) before fully tightening with the supplied 6 mm Allen wrench.
9
