AquaPRO PRO1100e TCE Time Clock Override TCO Operation cont, PRO1300, TCO wiring diagram, Phone

PRO1300, PRO1100e, PRO1300h/c, PRO1100,

PRO1300h/c TCE, PRO1300 TCE, PRO1100e TCE

PRO1100e

MY-TECH PH-111A

Brown

Brown & White

TCE

FAN

and

PRO1300

TCE

SPR1

SPR2

REVR

JANDY

AC

F1

F2

F3

HP

LP

FLO

COMP

PUMP

White

Black

12

~8

~12

WS

DS AS

P/S

Black

Blue

Red

Water Sensor

Gray

12 VAC

Yellow

Black

Black

Blue

Blue

Defrost Sensor

Black

Black

12 /

L2 L1

To Remote System

24 VAC

Transformer

(If Applicable)

High Pressure Switch

Black

Yellow

24 VAC

Closed = OK

Black

24

Opened = High Pressure

Yellow

Compressor

Vac

Blue

Contactor Coil

Low Pressure Switch

Blue

Closed = OK

Blue

L3 L4

Opened = Low Pressure

Red

Flow Switch

Orange

C

Orange

Closed = Flow

R

Opened = No Flow

COMPRESSOR

S

Run Cap

24 VAC

pool pump

Red

H

F

contactor coil

Black

C

Pool Pump

Figure 7 - PRO1100e TCE & PRO1300 TCE wiring diagram

Time Clock Override (TCO) Operation (cont.)

	T2	T1
INSIIDE	CONTACTOR
HEAT	FOR THE
PUMP	TIMETIMECLOCK
	CLOCK
	OVERRIDE
	OVERRIDE
	L3	L4
BREAKER
	TIME		FILTER
	CLOCK		PUMPP
Figure 8 - TCO wiring diagram
(optional)

•This unit is prepared at the factory with the “FIL” mode set to the “off” position. You will need to set the heat pump’s hours of run time in the “FIL” mode to “2” hours. See “activating and setting system run time” below to set the run time. Leave your time clock set to the desired pump and filter operation time. This will enable the heat pump and filter system to run the desired hours of the day and also provide the benefit of checking if heat is needed every 4 hours. It will do this by running the pump and filter system for 15 minutes. If heat is needed, it will continue to run until the pool has reached the set temperature. If no heat is needed, the system will turn off and continue checking for heat every 4 hours. This provides a couple of added benefits. Pools will lose most of their heat at night if left uncovered, however, since the unit is checking for and adding

heat when needed, it prevents long recovery times when compared to non- TCO units. The other benefit is that some states and electric utility companies offer a discount for off-peak usage of electricity. Please contact your electricity provider if you have questions.

Activating and Setting System Run Time – TCO Operation

•To set the run time of the system, push the “SET” button repeatedly until “FIL” displays. Then using the “up” and “down” arrows, set the hours to “2”. The range of hours is “off” to 2, 3, 4,… up to 23 hours to “on”. By selecting “2” the heat pump will run every 4 hours for 20 minutes, checking if heat is needed. The unit leaves the factory with the “FIL” mode set to “OFF”.

Phone: (877)-278-2797 www.aquaprosystems.com

7