10Once the hopper is assembled, make sure that the latch is closed and lay the hopper on its side. Next, locate the square tubing stub leg
kit (3 pieces) and unwrap. Take one stub leg and locate the recessed cavities on the funnel portion of the hopper. Place the stub leg into any cavity so as it fits snug. Make sure that the stub leg is angled outward away from the hopper. Repeat this step for the remaining two stub legs. Note that there are three cavities in the hopper and it does not matter where you start (Illustration H).
(Illustration H)
11Again, make sure that the angled portion of the stub leg extends out away from the
bottom of the drum. Next, locate the
12Now, take the piece with the round un- crimped end and face it upward, slide 3
pieces into it in the same direction (Illustration I).
13Repeat step #12 for the assembly of the two remaining leg sections.
(Illustration I)
PAge 7
