TV+ | MANUAL V1.0 | STARTING UP > P. 9 |
THE INSTALLATION WIZARD
•6JG+PUVCNNCVKQP9K\CTFYKNNJGNR[QWEQPÒIWTGVJGOCKPHWPEVKQPUQHVJG#4%*15
•If you ever need to relaunch the Installation Wizard, press the reset button. The
#4%*15YKNNTGUVCTVCPFCOGUUCIGYKNNRQRWRVQEQPÒTOVJGTGNCWPEJQHVJG YK\CTF+H[QWFQPQVTGURQPFYKVJKPUGEQPFUVJGYK\CTFYKNNDGCWVQOCVKECNN[ relaunched.
ATTENTION: if you use the reset button and relaunch the wizard, no data will be erased but your TV connection settings will be lost, and you will have to set them up again through the wizard.
NAVIGATING INSIDE THE WIZARD
•In the different screens of the wizard, use the up/down navigation buttons on the remote control to highlight a parameter.
•Use the left/right buttons to select a different setting for a parameter.
•9JGP[QWJCXGÒPKUJGFCFLWUVKPI[QWTUGVVKPIUWUGVJGPCXKICVKQPDWVVQPUVQJKIJ- light “Next” and press OK on the remote control to move on to the next screen.
•If you want to go back to a previous screen, select “Previous”.
CONFIGURING THE WIFI/ETHERNET CONNECTION
•At the end of the Installation Wizard, in the “Network” screen, you are invited to
EQPÒIWTG[QWT9K(K'VJGTPGVEQPPGEVKQP
•Choose “WiFi”, “Ethernet Cable” (standard Ethernet cable not supplied) or
“None”, based on the way you want to connect to the Internet (or local network). If you do not have access to the Internet, select “None”.
•See “Network” Settings.
TURNING THE ARCHOS ON/OFF
•Press the Power button 
on the remote control to turn on your ARCHOS or put it into standby mode.
•The green LED indicator, on the front of the device, lights up when the device is on. The red LED lights up when the device is in standby mode.
