NOTICE: Do not tighten hardware before reviewing ADJUSTING STEERING LEVERS on page 23. If no adjustment is desired tighten hardware.
4.Adjust steering levers (see ADJUSTING STEERING LEVERS on page 23).
Refer to Engine Manual.
Level Mower Deck
|
|
|
|
|
|
|
|
|
|
|
| 1 |
| ||
|
|
|
|
|
|
|
|
|
|
|
| 3 |
|
|
|
|
|
|
|
|
|
|
|
| 2 |
|
|
|
|
| |
1. | Steering Lever | 3. Steering Lever | |||||
2. | Steering Pivot |
| Hardware | ||||
| Arm |
|
|
|
| ||
Figure 3
Place Discharge Chute in Operating PositionFill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK on page 15.
Adjust SeatSee Adjusting Seat on page 14.
Check Safety Interlock SystemWARNING: Safety interlock failure and improper operation of unit can result in death or serious injury. Check system before each use to make sure it is functioning properly.
See Safety Interlock System on page 12.
Check function of all controlsSee Operation on page 12.
WARNING: Do not operate |
| Check Tire Pressure |
mower unless the discharge chute |
|
|
| CAUTION: Avoid injury! Explosive | |
is in the operating position. |
| |
| separation of tire and rim parts is | |
|
| possible when they are serviced |
Prior to operating the unit, remove the |
| incorrectly: |
| • Do not attempt to mount a | |
discharge chute from the transport position |
| tire without the proper |
and place the discharge chute in the |
| equipment and experience |
operating position (figure 4). |
| to perform the job. |
|
| • Do not inflate the tires above |
| Transport Position |
| the recommended pressure. |
|
| • Do not weld or heat a wheel |
|
| and tire assembly. Heat can |
|
| cause an increase in air |
|
| pressure resulting in an |
|
| explosion. Welding can |
|
| structurally weaken or |
|
| deform the wheel. |
|
| • Do not stand in front or over |
|
| the tire assembly when |
|
| inflating. Use a |
|
| and extension hose long |
|
| enough to allow you to stand |
|
| to one side. |
| Operating Position |
|
|
| ||
|
|
Figure 4
EN - 11