![](/images/backgrounds/98165/98165-3422x1.png)
SERVICING BATTERY
NOTICE: Unit comes equipped with a
This style battery can be replaced with a standard size U1 battery.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
Battery Removal and Installation Remove
1.Tip seat forward (see TIPPING SEAT FORWARD on page 19).
2.Disconnect negative
3.Loosen and remove taptite fastener (2) from battery bracket (1).
4.Remove battery bracket.
5.Remove and properly dispose of old battery.
Install
1.Remove taptite fastener located by battery decal.
2.Install replacement battery into battery channel.
3.Rotate and align battery bracket lengthwise to battery, ensuring tab corner is flush with battery.
4.Reinstall taptite fastener and tighten.
5.Apply petroleum jelly or dielectric grease to battery cable ends and terminals.
6.Connect positive (+) cable first, then negative
7.Tip seat back (see TIPPING SEAT FORWARD on page 19).
Cleaning Battery and Battery Cables
1.Tip seat forward (see TIPPING SEAT FORWARD on page 19).
2.Disconnect negative
3.Clean battery cable ends, negative
4.Apply petroleum jelly or dielectric grease to battery cable ends and terminals.
5.Connect positive (+) cable first, then negative
6.Tip seat back (see TIPPING SEAT FORWARD on page 19).
|
|
1.Battery Bracket
2.Taptite Fastener
Figure 18
EN - 22