3.Remove the snow
4.Replace the snow
Discharge Chute Deflector
ALWAYS position discharge chute deflector at a safe angle before starting engine.
DO NOT throw snow any higher than necessary.
Push deflector handle forward or down to throw snow lower. Pull deflector handle up or to the rear to throw snow higher.
IMPORTANT: If Chute Deflector does not stay in set position, adjust as directed in SERVICE AND ADJUSTMENTS on page 25, or repair before operation.
Remote Discharge Chute
Deflector Control (920014)
Place deflector into position before operation. DO NOT throw snow any higher than necessary.
Place deflector remote in a forward notch to throw snow lower. Place deflector remote in a rearward notch to throw snow higher.
Discharge Chute
Discharge chute rotates 205°.
ALWAYS position discharge chute in safe direction and angle, away from operator and bystanders, before starting engine.
Discharge Chute Crank
IMPORTANT: If chute does not stay in set position, adjust as directed in SERVICE AND ADJUSTMENTS on page 25, or repair before operation.
Rotate the chute with the discharge chute crank handle.
IMPORTANT: DO NOT force frozen chute controls. If frozen, take to warm place until controls are free.
Axle Lock Pin
(Figure 18)
Use the axle lock pin to lock or unlock the right or left wheel. Lock both wheels to increase traction; unlock one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
Wheel Unlocked
Wheel Locked
OS8185
1. Axle Lock Pin
Figure 18
Scraper Blade
The scraper blade allows the back of the housing to keep better contact with the surface being cleared. It also prevents damage to the housing from normal use.
IMPORTANT: DO NOT allow Scraper Blade to wear too far or Auger/Impeller housing will become damaged.
Skid Shoes
The skid shoes control the distance between the scraper blade and the ground. Adjust skid shoes equally to keep blade level with the ground. Refer to
GB - 18