Ariens 920013 - COMPACT 24 LE, 920013 COMPACT 22 LE, 920014 COMPACT 24 LE Service Position, INTERLOCK, CHECK FASTENERS, SERVICE POSITION, CHECK DUAL HANDLE, MAINTENANCE SCHEDULE

MAINTENANCE

Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center.

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

SERVICE POSITION

(Figure 19)

WARNING: Before tipping unit up onto housing, close fuel shut-off valve, and drain fuel tank and fuel system so no spills will occur (see engine manual for complete instructions). Ensure unit is secure and will not tip over during maintenance.

Place unit on a flat level surface. Tip unit forward onto front of auger housing for service. Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed.

Service Position

Figure 19 OS8190

MAINTENANCE SCHEDULE

The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required.

MAINTENANCE SCHEDULE

Service	Each	Every	Every	Yearly
Performed	Use	5 hrs.	25
			hrs.
Check Dual	•
Handle
Interlock
Check	•
Fasteners
Check Clutch	•
Operation
Clean Engine	•
Check Engine		•
Oil
Change
Engine Oil**
Check Tire			•
Pressure
Check Auger			•	•
Gearcase
General			•	•
Lubrication

**Refer to Engine Manual for detailed instructions.

CHECK DUAL HANDLE

INTERLOCK

Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage.

CHECK FASTENERS

Make sure all hardware is tightened properly.

GB - 22